Buzz/Whine sound. All meters in the RED

I posted this in PT Mac software. Thought I'd try here. From last night: I'm running PT10 on 27" iMac with a Digi 002. My hard drive is a Glyph GT050Q. I finished recording a guitar track and inserted IK's White 2A Leveling Amplifier on the track and all of sudden I get a loud buzzing/whine sound and all the meters go into red across the board including the Cue mix. When I hit play it goes away and comes back when I pause. I turned everything off. Waited and loaded a different session. Same thing. I turned everything off. I loaded PT and created a new session named it "Buzz Test" No buzz everything is fine. Did a line check with a mic and got a signal. No prob. Save the session. Opened up the previous session I was working on and got the Buzz in pause/fmeters in Red. Opened up a different session from before. Same thing. It seems a new session is fine but any previous saved session suffers this buzz/meters going into the red across the board. What's going on? I'm really nervous.



Today: Pro Tools loads about half way then I get a message "Pro Tools quit unexpectedly" After a couple lauches, PT loaded the session in question. No buzz/whine/dimed meters. Hit play. Pause/play buttons lights… no play. Wait note was not activated in transport. Close session. reopen. Same issues as before Buzz/whine/dimed meters are back. Close session buzz/whine continues untill I close out of PT. Researching the DUC. This is not a ground issue. Something happened when loading the White 2A amp. Is this a coincidence? Do you think it's the plug in? Should I reinstall it? Contact IK ? It's not the 002 harness as it's working fine. I copied and pasted the error report. Unfortunetly it's over 11k of charecters. DUC allows 2000. HELP !!!



BTW…. I just inserted the White 2A amp on a track in the "Buzz Test" session. No problems…. What's going on?