This should be an easy one for me but I can't figure it out.
When I grab an automation line in the edit window (In this case my Threshold for Channel strip) It keeps grabbing only the section of the clip instead of the entire line thats spans over multiple clips.
this used to not happen and now its happening all the time frustrating me.
If I could think of a better way to explain it I would but I really can't
I have like 40 clips of dial strung together on a track. I then want to adjust the threshold for all those clips so I do so. Then later when I want to re adjust the threshold Its only grabbing a small section of my whole automation line. Trying to match up with the small clip above.
I hope some of that makes sense.. Its driving me nuts..
kd
When I grab an automation line in the edit window (In this case my Threshold for Channel strip) It keeps grabbing only the section of the clip instead of the entire line thats spans over multiple clips.
this used to not happen and now its happening all the time frustrating me.
If I could think of a better way to explain it I would but I really can't
I have like 40 clips of dial strung together on a track. I then want to adjust the threshold for all those clips so I do so. Then later when I want to re adjust the threshold Its only grabbing a small section of my whole automation line. Trying to match up with the small clip above.
I hope some of that makes sense.. Its driving me nuts..
kd
Aucun commentaire:
Enregistrer un commentaire