Hey all, thanks in advance. My SC48 (not remote) from 2009 just developed a strange fader problem. I was switching input card 1 & 3, because slot 7 of card 1 has an issue. When I put it back together & started testing, the input faders started jumping around if you moved them while pressing down normally on them. If you push to the side or pull up on them it doesn't happen. For example, take fader 1, put normal downward pressure, then push it all the way up, on the screen it slowly creeps upwards until you let off pressure, then jumps to where you leave it.
Output faders are fine, as is Flex & master fader. And faders 4-5 in each bank of inputs work fine. I switched the connector from fader 3 & 4 and the problem followed the connector, so its not the fader itself. I reseated every connector on both the fader banks & the top panel. I'm at a loss now. Could it be software related? Any help would be great as the console is open now & will be at a show tomorrow.
Thanks, be safe.
Output faders are fine, as is Flex & master fader. And faders 4-5 in each bank of inputs work fine. I switched the connector from fader 3 & 4 and the problem followed the connector, so its not the fader itself. I reseated every connector on both the fader banks & the top panel. I'm at a loss now. Could it be software related? Any help would be great as the console is open now & will be at a show tomorrow.
Thanks, be safe.
Aucun commentaire:
Enregistrer un commentaire