Hey guys,
About 2 hours into my work day, I tried adjusting the monitor volume on the omni and noticed that it was stuck and not changing. I then realized that none of the buttons were doing anything and it seemed frozen. I then powered down the unit and turned it back on to find no display at all. I restarted everything and powered on again without Pro Tools open and the power light switched from orange to green right away but still no display on the unit (usually the power light stays orange until pro tools is launched). Pro tools starts fine, so its still recognizing the unit, but nw I can't get any sound out and the display is dead. I tried switching power cables and even running on a different circuit and one time I turned it on and it the display came back but then when I power cycled once more the problem came back. Did this thing really just die on me? I've only had it for a couple years.
About 2 hours into my work day, I tried adjusting the monitor volume on the omni and noticed that it was stuck and not changing. I then realized that none of the buttons were doing anything and it seemed frozen. I then powered down the unit and turned it back on to find no display at all. I restarted everything and powered on again without Pro Tools open and the power light switched from orange to green right away but still no display on the unit (usually the power light stays orange until pro tools is launched). Pro tools starts fine, so its still recognizing the unit, but nw I can't get any sound out and the display is dead. I tried switching power cables and even running on a different circuit and one time I turned it on and it the display came back but then when I power cycled once more the problem came back. Did this thing really just die on me? I've only had it for a couple years.
Aucun commentaire:
Enregistrer un commentaire