I just installed PT 12 on my 10.10 system. Loaded up a new session and went to create a chain of aux busses, only to find that the bus amount was maxed out to what my interface has (Saffire Pro 24, so 24 busses total).
I went into I/O settings and defaulted everything, and still it would only max out at 24 busses.
PT 11 on the other hand, runs perfect. When I use the same project created in 12, hit default on the BUS page, it shows 100+ available. Saved in PT 11, opened again in PT 12, and voila, all the busses created in 11 continued over to 12.
Is this a glitch in 12? or am I missing a checkbox?
Cheers!
I went into I/O settings and defaulted everything, and still it would only max out at 24 busses.
PT 11 on the other hand, runs perfect. When I use the same project created in 12, hit default on the BUS page, it shows 100+ available. Saved in PT 11, opened again in PT 12, and voila, all the busses created in 11 continued over to 12.
Is this a glitch in 12? or am I missing a checkbox?
Cheers!
Aucun commentaire:
Enregistrer un commentaire